3 in 1 Waterproof LED Electronic Meter Motorcycle Digital Time Clock Thermometer VoltmeterBlue Light

How to Use 1. Wiring method: the red wire is connected to the positive electrode of the battery, the black wire is connected to the negative electrode of the battery, and the blue wire is connected to the main power switch. 1 x Motorcycle Electronic Meter 1 x Base 2 x Screw 2 x Cable Ties 1 x Double Sides Adhesive Tape

• Powerful, three‑in‑one electronic meter, with voltmeter, electronic clock, and thermometer functions.
• Press the button to switch the display mode, let the information be clear at a glance, pay attention to the time at any time, and keep you away from danger.
• Large-screen digital display, large-scale electronic screen, the numbers are bright and easy to see, and they are still clearly visible during the day.
• Easy to install, equipped with a base and cable ties, the installation is firm, not easy to fall off. Safe voltage, 12V low voltage, rest assured to use.
• IP67 waterproof and dustproof, the shell is tightly sealed, waterproof and dustproof, so you can use it at ease.
• After power on, the boot screen will be displayed, and then the time will be displayed (the initial time after power off is 12:00)
• The time is 24 hours, the voltage is 12V, and the temperature range: -20°C to 70°C
• In the power-on state, the hour segment flashes after long pressing the button for 2 seconds, which means that when entering the hour setting, each short press of the button will add 1 hour (24-hour system).
• After the time is set, long press the button for 2 seconds again, and the minute segment flashes, indicating that the minute setting is entered. At this time, each short press of the button will increase by 1 minute.
• After setting the minutes, press and hold the button again for 2 seconds to exit the time setting.