4Pcs 3D Printer Flat Bed Die Springs Level Upgrade Kit Ender 3 Pro V2 Cr-10 Cr-X

Item price

$2.95

Delivery is calculated at checkout — the total you see before you pay is the total you pay.

In stock · ready to order

Estimated delivery Thu, 10 Sept – Fri, 18 SeptShips from Australia · we email your tracking number as soon as it ships. An estimate, not a guaranteed delivery date.

Delivery & checkout

Delivery postcode

Quantity

Total to pay$2.95+ delivery

VISAAMEXafterpayZip.

$2.95

Delivery at checkout

Product details

This is one of the best upgrades you can do to your printer. The 25mm length is the correct spec for the spring - years ago, people used 20mm springs, but those can be too short in some cases. Note for the Ender 3 V2: If you have trouble fitting the springs, raise the Z Stop just a touch. It may have been installed too low. The Z Stop is the limit switch attached to the upright on the extruder side. Each item consists of a set of 4 springs. NOTES Please allow a 1-3 cm difference due to manual measurements. Please note that slight colour differences should be acceptable due to the light and screen.

Warranty & returns

Change of mind? Return it within 30 days in original, unused condition.

Anything faulty, damaged in transit, or not as described is always covered under the Australian Consumer Law — you're entitled to a repair, replacement or refund. Manufacturer warranty also applies where the maker offers one.

Delivery policy

We deliver right across Australia. Your delivery cost is worked out from your address at checkout — the total you see before you pay is the total you pay, with no surprises after.

Orders are dispatched by our supplier or delivery partner and tracked to your door. You'll get tracking by email as soon as it ships.