Office & Stationery
4Pcs 3D Printer Flat Bed Die Springs Level Upgrade Kit Ender 3 Pro V2 Cr-10 Cr-X
Item price
$2.43
Delivery is checked for your postcode before you pay — no surprises at checkout.
In stock · ready to order
$2.43
+ delivery — enter your postcode:
Product details
About this item
This is one of the best upgrades you can do to your printer. The 25mm length is the correct spec for the spring - years ago, people used 20mm springs, but those can be too short in some cases. Note for the Ender 3 V2: If you have trouble fitting the springs, raise the Z Stop just a touch. It may have been installed too low. The Z Stop is the limit switch attached to the upright on the extruder side. Each item consists of a set of 4 springs. NOTES Please allow a 1-3 cm difference due to manual measurements. Please note that slight colour differences should be acceptable due to the light and screen.
Product availability was last imported 4 Sept. Checking delivery does not create a supplier order, payment or stock reservation.